How to achieve ASML cleanliness requirements with wire EDM
De Run 1115 ,5503 LB Veldhoven
Event informatie
--
Choosing between two evils is how you could label the dilemma that wire EDMs have when they make parts for the high-vacuum part of ASML's machines. When they cut with coated brass wire, they have a stable process with good speed. But zinc and copper particles settle on the surface, leading to rejection because of cleanliness requirements. The alternative so far is cutting with molybdenum or tungsten wire. But this wire is stiff, breaks quickly, cuts slowly and is up to about 20 times more expensive than coated brass wire.
Onze sprekers Downloads
Programma
- 13.30 - 14.00 Welcome
- 14.00 - 14.30 Opening & presentation Sommen-edm
- 14.30 - 15.00 How to reach grade 1-2 requirements after Wire-EDM
- 15.00 - 15.15 Break
- 15.15 - 15.45 Practicle examples
- 15.45 - 16.00 Q&A
- 16.00 - 17.00 Drinks
Onze sprekers
Downloads
Informatie PDF
Interviews & foto galerij
Contact
Beschikbare locaties
- - De Run 1115, 5503 LB Veldhoven
Beschikbare plaatsen: 30
"*" geeft vereiste velden aan
Bezoek ook onze andere websites
The KSC is the connector between companies from the design and manufacturing industry, which bundles knowledge in an accessible way to achieve joint growth and collaborations.
Bezoek de website
Sharing knowledge to promote joint growth and collaboration.
Bezoek de website
Success stories are educational and encourage collaboration.
Bezoek de website